22090 Series

Heat/Cool Unit

22090B000C

22090B000C
Tubes point toward left hand side when viewed from the back

Specifications

• BTU HEAT - 43,6000/COOL - 32,000
• 580 CFM FREE BLOW
• AMP DRAW HIGH - 19
• 3 SPEED - 12 VOLT
• WEIGHT - 28 LBS.
• DIMENSIONS - 9 5/16H X 17 7/8W X 15 3/16D

Features

• The new standard for the ambulance/emergency vehicle industry.
• Front removable, dynamically balanced blower assembly. Long-life permanent magnet motor has ball bearings, extended life brushes and a custom wound armature specific to the application.
• Exclusive drain pan design immediately drains almost all condensate, helping prevent mildew, odors and spillage caused by rapid acceleration or braking. A copper drain tube replaces glued on plastic tubes. A hold down bracket attached with weld studs holds the drain hose securely in place, eliminating strain from the pan.
• Ceramic potted resistor provides precise speed control and eliminates exposed ballast wires.
• All connections have weld nuts for positive thread to thread connections and eliminates the use of sheet metal screws.
• Integral strain relief brackets are provided to secure refrigerant lines directly to the unit, eliminating stress points caused by hoses.
• Insulation on the drain pan and inside the metal case minimize "sweat" type condensation problems.

Parts Listings

Capacities vary depending on the rating condition used.
Specifications subject to change without notice.